Ni Battery 4 Serial Number UPDATED
DOWNLOAD - https://bytlly.com/2t9PuE
Disconnect the old battery from the console before servicing it. In addition, remove the protective film from both the negative and positive terminals of the old battery and remember to reconnect the new battery in the same order. Figure 3 shows a fully charged battery, ready to be installed.
When buying a new battery, look for:
High-capacity cells
Fully charged cells
Fully-cut interconnects
No loose or damaged connectors
If applicable, a charger that also applies the series connection
This parallel arrangement is also useful if a battery has been overcharged. Only one of the parallel cells will reach the maximum charge but the others are unaffected. Attempting to discharge the pack will not damage any cells. Care should be taken not to exceed the battery capacity when charging the parallel string in this way.
In extreme cases, if only one cell in a parallel string is damaged, the damaged cell can be replaced. The remaining cells and module are unaffected. Figure 5 illustrates a bad P3 battery.
Cells in the left column are checked and the cells in the right column are not checked. The cells that are not checked will undergo a chemical reaction during the discharge cycle. The process of checking and un-checking the cells is an important step for battery usage. It is recommended to check all the cells in a pack as early as possible.
The analogy below explains the procedure for checking and un-checking cells. For example, the first cell in the pack is checked. Do you pass the check for that cell? If the answer is no, move to the next cell. If the answer is yes, do not pass the check on the next cell. Thus, the following process is repeated until the last cell of the pack is checked. The checking and un-checking of the cells is an important step for battery usage. It is recommended to check all the cells in a pack as early as possible.
The battery pack shown in Figure 4 consists of four 3.6V cells in parallel. If the cells are series connected, the battery pack will have a voltage of 14.4V. However, if the cells are connected in parallel the voltage of the pack will drop to 12.2V. 827ec27edc